POW Gloves recommends Nikwax for glove care:

Waterproofing Wax for Leather for smooth leather gloves.

Glove Proof for synthetic or mixed fabric gloves.

General Tips

• Always clean your gloves before re-waterproofing them.
• When cleaning leather gloves, NEVER wash them in the washing machine.
• Do not turn lined gloves inside out. The liner, insulation, and membrane can be very difficult to put back into place.
• Gloves with removable lining dry faster when the liners are removed, and these liners are easy to wash, too.
• Always dry your gloves at room temperature. Avoid heaters, driers, and ovens.
• Gloves dry best in an upright position.

Care by material type

Leather Gloves/Mitts

Leather is all natural; it needs regular care for best results. Reapplying leather oil and water treatments will help ensure years of product life. Visit Nikwax.com for more products & information or go check out the POW / Nikwax product care video on this page for a quick rundown of leather glove care.

Nikwax treatment may alter the color of the leather (sometimes darkens, slightly), so test on a small area to be sure you like the look. Oftentimes, worn and faded leather nearly returns to its original shade. Be careful with white leather applications: spot check before applying to entire glove to ensure no discoloration occurs.

Easy To Apply

• To apply the Nikwax Waterproofing Wax for Leather, put the gloves on normally, squeeze a Hershey’s kiss amount onto your palm, and then spread it around your hands evenly, as though you are applying hand lotion.
• Be sure to rub it deep into seams, massaging it until it is completely rubbed in. Remove any excess with a cloth or napkin.
• No baking or heating is necessary to activate the waterproofing. It works immediately!
• Treat every 30-60 days, or as needed for optimal waterproofing.

Synthetic and Mixed-Fabric Gloves

• Clean/wash your gloves first (Nikwax Tech Wash). You can toss them in with a load of your ski or snowboard shells and do 3-4 garments at a time with Tech Wash.
• While the gloves are still wet, apply Nikwax Glove Proof with the applicator sponge, paying special attention to seams. Remember to push down on the brush tip to break the seal. You will feel or hear a little pop. As you apply the treatment, be sure to cover the entire outer surface of the glove.
• After a few minutes, remove any excess solution with damp cloth.
• Allow to dry naturally.